This is a development board with a Philips LPC2294 ARM processor. This chip has 256Kb Flash, 16Kb RAM, an RTC, 4 10-bit ADC inputs, 2 UARTs, 4 CAN interfacesI2C, SPI, 2 32bit timers, 7 CCRs, 6 PWM, WDT, 5V tolerant I/O. It has a Wiggler-compatible JTAG interface, a reset button, and a status LED. The chip has an external memory bus. On this bus 8Mb RAM and 1Mb FLASH are available. The board has a CS8900A ethernet interface. An SD card connector is located on the bottom side of the PCB. It has a serial interface that can be used for bootloading with the Philips bootloader, and/or or for serial communcation.
The board requires an external power supply. A 6V DC wall-wart will do. The board itself consumes less that 800 mA.
manufacturer: Olimex
Related products: |
ARM-USB-JTAG | USB JTAG interface for ARM development boards |
|
ARM-USB-TINY-JTAG | USB JTAG interface for ARM development boards |
|
ARM-USB-EW-JTAG | USB JTAG interface for ARM development boards |
|
ARM-PAR-JTAG | parallel port JTAG interface for ARM development boards |
|
ST-LINK-01 | ST link STM32 programmer clone |
|
DB100 | DB100 LPC USB serial downloader |
|
MOD-I2C-SHIFT-01 | I2C level shifter board |